Kurzweil pcx1inst 사용자 설명서
16
The Polyphony Expansion Kit
Installing in Rack-Mount Models
Figure 5
Removing the top panel
Installing the PCX-1 Board
1. Locate the Engine board (see Figure 6), and identify the four white plastic standoffs
(vertical pins) that will hold the PCX-1 board in place. Also notice the 24-pin male
connector on the Engine board. This will plug into the connector on the PCX-1 board.
connector on the Engine board. This will plug into the connector on the PCX-1 board.
2. Identify the 24-pin female connector (J805) on the PCX-1 board. It’s on the bottom of the
board—all of the other components are on the top of the board. Also notice the four holes
that will align with the standoffs on the Engine board.
that will align with the standoffs on the Engine board.
3. Align the holes in the PCX-1 board with the standoffs on the Engine board. This will align
the connectors. All four standoffs on the Engine board should protrude through the PCX-1 board. The two standoffs on the bottom panel of the PC2R should align with the holes at the right edge of the PCX-1 board.
Figure 6
Inserting the PCX-1 board
24-pin male connector
on Engine board
on Engine board
24-pin female connector
on PCX-1 board
on PCX-1 board