Garmin g1000 beechcraftbaron58 g58 pilots guide 사용자 설명서
Garmin G1000 Pilot’s Guide for Beechcraft 58/G58
190-00629-00 Rev. B
6-4
ENGINE INDICATION SYSTEM
6.3 LEAN PAGE
The Lean Page is accessed by pressing the LEAN
softkey and provides information and a user interface
for performing engine leaning. The dial gauges and Fuel
Flow Indicator remain on the Lean Page.
for performing engine leaning. The dial gauges and Fuel
Flow Indicator remain on the Lean Page.
CHT Readout
(Selected Cylinders)
Cylinder Head
Temperature
Bar Graph
EGT Readout
(Selected Cylinders)
Exhaust Gas
Temperature
Bar Graph
Figure 6-5 Lean Page
Manifold
Pressure Gauge
Fuel Flow
Indicator
Tachometer
Fuel Flow
Leaning Marks
Propeller Sync
Indicator
NOTE: The pilot should follow the engine
manufacturer’s recommended leaning procedures
in the Pilot’s Operating Handbook (POH).
manufacturer’s recommended leaning procedures
in the Pilot’s Operating Handbook (POH).
Temperature Bar Graphs
The EGT and CHT Bar Graphs display the relative
exhaust gas and head temperature for all cylinders of each
engine and give numeric readouts in degrees Celsius for
the selected cylinders.
engine and give numeric readouts in degrees Celsius for
the selected cylinders.
By default, the hottest cylinders are selected, as
indicated by cyan (light blue) highlighting. Bars appear
in white for both graphs to indicate temperatures in the
normal range. A CHT above 238 °C (indicated by the
red line at the top of the graph) causes the bar for that
cylinder to become red.
in white for both graphs to indicate temperatures in the
normal range. A CHT above 238 °C (indicated by the
red line at the top of the graph) causes the bar for that
cylinder to become red.
Lean Page Softkeys
The pilot can utilize the CYL SLCT and ASSIST
softkeys to obtain information about specific cylinders
while on the Lean Page.
while on the Lean Page.
Cylinder Select
NOTE: The CYL SLCT softkey is disabled while
Lean Assist Mode is active (the ASSIST softkey
is pressed).
Lean Assist Mode is active (the ASSIST softkey
is pressed).
The CYL SLCT softkey is available from the Lean Page
and can be utilized to obtain EGT and CHT information
about a particular cylinder. Pressing the softkey cycles
through the cylinders of both engines simultaneously.
about a particular cylinder. Pressing the softkey cycles
through the cylinders of both engines simultaneously.