Dodge 2007 sprinter 사용자 설명서

 Then press 0 on electric air pump 

switch 1.
The electric air pump is switched off.

 Screw the valve cap onto tire valve b.
 After filling with tire sealant 

 Turn the pressure release screw on 

pressure gauge 5 counterclockwise 

and bleed the system.

 Turn the key to position 0 in the igni-

tion lock (

 Pull the electric air pump connector out 

of the 12 V socket.

 Store the electric air pump, tire sealant 

bottle 8 with valve core extractor c 

and, if used, the warning triangle and 

hazard warning lamps inside the vehi-

cle.

 Unscrew and remove angle bracket 2 

from valve 7 on tire sealant bottle 8 

and screw the valve cap onto the valve.

 Pull away immediately.

This enables the tire sealant to distrib-

ute inside the tire and create a more ef-

fective seal.

 Stop after about 3 minutes and check 

the tire pressure using the electric air 

pump, for example.

 Correct the tire pressure accordingly if 

it does not correspond to the recom-
mended tire pressure (

Increasing the tire pressure
 Switch on the electric air pump.
Reducing the tire pressure
 Open the pressure release screw 

on pressure gauge 5.

 Drive to the nearest workshop and 

have the tire repaired or replaced.

 Clean the valve core extractor using 

clean water.

 Have tire sealant bottle 8 replaced as 

soon as possible at an authorized 

Sprinter Dealer.

i

The tire sealant is water soluble. If tire 

sealant escapes, you can wash it away 

with water.

G

Do not exceed the maximum speed of 
50 mph (80 km/h).

The "max. 50 mph (80 km/h)" sticker must 
be affixed within the driver's field of vision.

The vehicle’s handling characteristics may 
be affected.

i

You must connect the angle bracket on 

hose 3 of the electric air pump direct-

ly to the tire valve on the tire.