Crestron 1700c-bezel 사용자 설명서

Bezel Kit 

Crestron 1700C-BEZEL 

Perform the following to remove the existing bezel, pushbuttons, and 
supporting parts from the Series 1700 touchpanel and install the new 
replacement bezel. A #1 Phillips screwdriver is required. Refer to the 
illustrations that accompany the procedure.  

1.  Remove the battery and place the touchpanel face down on a 

clean padded work surface. 

2.  Remove the four screws that secure the front bezel to the base 

and return the unit to its normal position. (Use care and hold the 
bezel to the rest of the panel. If the bezel separates while 
rotating to its normal position, the internal parts of the panel 
may spill out.) 

Battery

Screw

Screw

 

3.  When in the normal position, lift the bezel from the touchpanel. 
4.  As shown in the illustration on the next page, remove the 

pushbuttons and the membrane switch actuators from the PCB 
surface. 

•  Bezel Kit:  1700C-BEZEL