Uniden BCT15 사용자 설명서
63
Programming General Settings
Set Record
This setting lets you enable the REC jack. Then you connect an audio cable to an
audio recording device such as tape, digital recorder, or hard disc of a computer.
Once set, you can record, in real time, incoming transmissions.
audio recording device such as tape, digital recorder, or hard disc of a computer.
Once set, you can record, in real time, incoming transmissions.
[MENU]
Set Bear Tracker
F
Set Record
F
to select On or Off.
Then
F
t o set your selection.
Max Priority Scan
This setting lets you choose how many BearTracker frequencies are checked
during use of the BearTracker Warning System. A lower number makes the break
shorter, but makes it more likely that some alerts are missed. A higher number
reduces the chance of missed alerts, but the breaks are longer.
during use of the BearTracker Warning System. A lower number makes the break
shorter, but makes it more likely that some alerts are missed. A higher number
reduces the chance of missed alerts, but the breaks are longer.
[MENU]
Set Bear Tracker
F
Max Priority Scn
F
Press a number key to enter a value between 001 and 255.
Press
F
to enter that value between 1 and 255.
If you exceed 255, and press
F
, you see
Out of Range, Set Max? (Y/N)
If you want to use the maximum setting, press
F
.
If not, press [.No] to cancel and enter a new number in range.
Note: This setting affects both the Bear Tracker channels and any priority
channels you have in active conventional systems.
channels you have in active conventional systems.
BearTracker Shortcut Options
• To lockout a freq, press [L/O] while monitoring an active channel.
• To toggle a lockout of a trunked system within the BearTracker system,
press
F
+ [L/O].
• hints...To enable attenuation of a strong signal, press
F
+ [7].
• To quickly lock or unlock a service, while in either Scan mode or Scan Hold
mode, press the service key based on the following table.