Nero nero cover designer 빠른 설정 가이드
Quickstart Cover Designer
Settings
• 11
You must pre-define any user-designed paper stocks before you can use them.
4.2.2 Printer Calibration
Because printers are mechanical devices that are subject to minimal variations
while printing, we recommend the you calibrate the printer once after you have
chosen the label type and selected the printer.
while printing, we recommend the you calibrate the printer once after you have
chosen the label type and selected the printer.
1. Prior to calibration, select the desired label type and the printer.
2. Select the 'Preferences' command on the 'File' menu and click on the
'Printing' tab.
3. Click on the 'Print Calibration Sheet' button.
4. Take the paper out of the printer. Fold the paper horizontally and vertically in
the middle.
The dotted line indicates the current calibration setting.
The dotted line indicates the current calibration setting.
5. Unfold the paper again and compare where the horizontal and vertical fold
lines meet the intersection of the axes.
The intersection point indicates printer deviation in millimeters relative to the
center of the page.
The intersection point indicates printer deviation in millimeters relative to the
center of the page.
6. If there is a difference between the fold lines and the current setting, enter
the actual horizontal and vertical values on the 'Printing' tab and then print
another calibration sheet.
another calibration sheet.
7. Fold that paper again horizontally and vertically in the middle. The fold lines
should now coincide with the dotted lines. If this is the case, you have
successfully competed printer calibration. (If not, repeat the appropriate steps
to perform the calibration.)
successfully competed printer calibration. (If not, repeat the appropriate steps
to perform the calibration.)
8. Click on the 'OK' button to close the tab and end calibration.