National Instruments DIO 6533 사용자 설명서
Chapter 5
Signal Timing
© National Instruments Corporation
5-3
DIO 6533 User Manual
Figure 5-3. External Request Timing
Trigger Timing
Using pattern-generation mode, you can configure the 6533 device to
accept both start and stop triggers.
accept both start and stop triggers.
The stop trigger is the primary trigger. The 6533 device can transfer
specified numbers of data both before and after a stop trigger. If you do
not enable a stop trigger, the 6533 device stops automatically after
transferring a number of data points equal to the size of your buffer.
specified numbers of data both before and after a stop trigger. If you do
not enable a stop trigger, the 6533 device stops automatically after
transferring a number of data points equal to the size of your buffer.
The start trigger is a second trigger that begins a pattern-generation
operation. If you do not enable a start trigger, the operation starts
immediately when you issue a software command to perform a transfer.
operation. If you do not enable a start trigger, the operation starts
immediately when you issue a software command to perform a transfer.
Triggers are available for both waveform generation (output mode) and
data acquisition (input mode). Acquiring data that occurs before or after
a trigger is known as pretrigger or posttrigger data acquisition,
data acquisition (input mode). Acquiring data that occurs before or after
a trigger is known as pretrigger or posttrigger data acquisition,
Parameter
Description
t
c
Cycle time
t
lw
Width of low pulse
t
hw
Width of high pulse
t
p
Propagation time to valid output data
t
su
Setup time
t
h
Hold time
Data (Output Mode)
Data (Input Mode)
REQ
th
tsu
10 ns
Min
20 ns
Min
tp
30 ns
Max
thw
20 ns Min
tlw
20 ns Min
tc
50 ns Min