Zebra 49834 사용자 설명서
114
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Troubleshooting
Miscellaneous Print Engine Problems
Changes in
parameter settings
did not take effect
parameter settings
did not take effect
Parameters are set incorrectly.
1.
Set parameters and save permanently.
2.
Turn the print engine power Off (O) and then
On (I).
On (I).
A ZPL command has turned
off the ability to change the
parameter.
off the ability to change the
parameter.
Refer to the ZPL Programming Guide.
A ZPL command has changed
the parameter back to the
previous setting.
the parameter back to the
previous setting.
Refer to the ZPL Programming Guide.
If the problem continues, there
may be a problem with the
main logic board.
may be a problem with the
main logic board.
Replace the main logic board.
The print engine
fails to calibrate or
detect the top of the
label.
fails to calibrate or
detect the top of the
label.
The print engine was not
calibrated for the label being
used.
calibrated for the label being
used.
Perform the calibration procedure in
The print engine is configured
for continuous media.
for continuous media.
Set the media type to noncontinuous media. See
The driver or software
configuration is not set
correctly.
configuration is not set
correctly.
Driver or software settings produce ZPL
commands that can overwrite the print engine
configuration. Check the driver or software
media-related setting.
commands that can overwrite the print engine
configuration. Check the driver or software
media-related setting.
Non-continuous
labels are being
treated as continuous
labels.
labels are being
treated as continuous
labels.
The print engine is configured
for continuous media.
for continuous media.
Set the media type to noncontinuous media. See
The print engine was not
calibrated for the label being
used.
calibrated for the label being
used.
Perform the calibration procedure in
The ribbon light is
on even though
ribbon is loaded
correctly.
on even though
ribbon is loaded
correctly.
The print engine was not
calibrated for the label being
used.
calibrated for the label being
used.
Perform the calibration procedure in
All lights on, but
nothing displays on
the LCD, and the
print engine
locks up.
nothing displays on
the LCD, and the
print engine
locks up.
Internal electronic or firmware
failure.
failure.
Turn the print engine power Off (O) and then
On (I). If the print engine locks up again, replace
the main logic board.
On (I). If the print engine locks up again, replace
the main logic board.
The print engine
locks up while
running the Power-
On Self Test.
locks up while
running the Power-
On Self Test.
Main Logic Board failure.
Replace the main logic board.
Table 15 • Miscellaneous Print Engine Problems (Continued)
Problem
Possible Cause
Recommended Solution