Zebra 49834 사용자 설명서
188
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Preventive and Corrective Maintenance
Print System—Printhead Installation
Printhead Installation
This procedure includes the parts and documentation necessary to install the replacement
printhead. Read these instructions thoroughly before attempting to install this kit.
printhead. Read these instructions thoroughly before attempting to install this kit.
Tools Required
Installation Instructions
1.
Turn Off (O) the print engine and disconnect the AC power cord and interface cables.
2.
Open the front cover, unlatch the printhead lever, and remove media and ribbon from the
print engine.
print engine.
3.
Close the printhead and then loosen the printhead mounting screw.
Caution • A qualified service technician must perform this installation.
Caution • Turn Off (O) the printer and disconnect it from the power source before
performing the following maintenance.
performing the following maintenance.
Anti-Static Wriststrap and Mat
DC Volt Meter
Metric Hex Key (Allen Wrench) Set
Standard Hex Key (Allen Wrench) Set
Utility Pliers
47362* Zebra Preventative Maintenance
Kit
Phillips Screwdriver Set
* A solution of 90% isopropyl alcohol and 10% deionized water and clean swabs may be used in place of
the Preventative Maintenance Kit.
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
static-sensitive components such as circuit boards and printheads.
Caution • Be careful not to touch the printhead with any tools. This could damage the
printhead.
printhead.
Note •
The following procedure references the right-hand print engine assembly. For left-hand
print engines, positions and rotations will be in the opposite direction.
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
printhead to cool.