Zebra 49834 사용자 설명서
238
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Preventive and Corrective Maintenance
Printed Circuit Boards—PCMCIA Board
PCMCIA Board
This procedure is for installing or replacing the PCMCIA option board assembly. Read these
instructions thoroughly before performing this procedure.
instructions thoroughly before performing this procedure.
Tools Required
Installation Instructions
1.
Refer to
and remove the print engine from the applicator.
Remove the PCMCIA Card
1.
. Remove the PCMCIA card shield by removing the shield screw.
2.
Remove any PCMCIA card from the card slot by pressing the card release button, if
necessary.
necessary.
The card release button is located near the card slot.
Figure 122 • Rear View of PCMCIA Card and Shield
Removal and Installation
Note •
You must have PAX firmware V60.13.0.4 or higher. You can download the latest
version of Zebra PAX firmware from the Zebra web site at
www.zebra.com
.
Phillips Screwdriver Set
Metric Nutdriver Set
Anti-Static Wrist Strap
Anti-Static Mat
Metric Hex Key (Allen Wrench) Set
PCMCIA
Card
PCMCIA
Card
Shield
Shield
Screw
PCMCIA
Card
PCMCIA
Card
Shield
Shield
Screw
Left-Hand
Right-Hand
Card
Release
Button
Card
Release
Button