Zebra 49834 사용자 설명서
Preventive and Corrective Maintenance
Printed Circuit Boards—DC Power Supply
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
269
DC Power Supply
This procedure is for installing or replacing the DC power supply. Read these instructions
thoroughly before performing this procedure.
thoroughly before performing this procedure.
Tools Required
Installation Instructions
1.
Refer to
and remove the print engine from the applicator.
Remove the Old DC Power Supply
1.
. Remove the AC power switch from the main frame and let it hang.
Do not remove any wires from the switch.
To remove the switch compress the mounting tabs while pushing on the rear of the switch
and gradually walking the switch out of the main frame.
and gradually walking the switch out of the main frame.
Caution • A qualified service technician must perform this installation.
Caution • Turn OFF (O) the printer and disconnect it from the power source before
performing the following maintenance.
performing the following maintenance.
Phillips Screwdriver Set
Anti-Static Wriststrap and Mat
Standard Hex Key (Allen Wrench) Set
Metric Hex Key (Allen Wrench) Set
Note •
Do not remove the wires from the AC power switch.