Zebra 49834 사용자 설명서
66
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Operations
Setup Mode Overview
Exit Setup Mode
To leave Setup mode, complete these steps:
1.
Press SETUP/EXIT.
The LCD displays
SAVE CHANGES
.
2.
Press the left or right oval to display the save options (
).
3.
Press NEXT to select the displayed choice.
When the configuration and calibration sequence is done,
PRINTER READY
displays.
Table 6 • Save Options When Leaving Setup Mode
LCD
Description
PERMANENT
Stores values in the print engine even when power is turned
off.
off.
TEMPORARY
Saves the changes until power is turned off.
CANCEL
Cancels all changes made since you entered Setup mode,
except for changes made to the darkness and tear-off settings,
which go into effect as soon as they are made.
except for changes made to the darkness and tear-off settings,
which go into effect as soon as they are made.
LOAD DEFAULTS
Restores all parameters other than the network settings back
to the factory defaults. Use care when loading defaults
because you will need to reload all settings that you changed
manually.
to the factory defaults. Use care when loading defaults
because you will need to reload all settings that you changed
manually.
Note •
Loading factory defaults causes the print
engine to auto-calibrate.
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Restores the wired and wireless network settings back to
factory defaults.
factory defaults.