Zebra 49834 사용자 설명서
68
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Operations
Front Panel LCD Displays
Adjust Print Speed
Adjusts the speed for printing a label (given in inches per second). Slower
print speeds typically yield better print quality. Print speed changes take
effect upon exiting Setup mode.
Adjusts the speed for printing a label (given in inches per second). Slower
print speeds typically yield better print quality. Print speed changes take
effect upon exiting Setup mode.
Default: 2 IPS
Range: 2 to 12 IPS for 203 dpi, 2 to 8 IPS for 300 dpi
To change the value shown:
1.
Press the right oval to increase the value.
2.
Press the left oval to decrease the value.
Adjust Slew Speed
Adjusts the speed for feeding a blank label (given in inches per second).
Adjusts the speed for feeding a blank label (given in inches per second).
Default: 6 IPS
Range: 1 to 12 IPS
To change the value shown:
1.
Press the right oval to increase the value.
2.
Press the left oval to decrease the value.
Adjust Backfeed Speed
If backfeed is on, adjusts the speed at which the label backs up before
printing (given in inches per second).
If backfeed is on, adjusts the speed at which the label backs up before
printing (given in inches per second).
Default: 2 IPS
Range: 1 to 12 IPS
To change the value shown:
1.
Press the right oval to increase the value.
2.
Press the left oval to decrease the value.
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing. Positive numbers move the media out
and negative numbers move the media in.
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing. Positive numbers move the media out
and negative numbers move the media in.
Each press of an oval adjusts the tear-off position by four dot rows.
Default: +0
Range: –120 to +120
To change the value shown:
1.
Press the right oval to increase the value.
2.
Press the left oval to decrease the value.
Table 7 • Print Engine Parameters (Sheet 2 of 28)
Parameter
Action/Explanation
PRINT SPEED
2 IPS +
2 IPS +
SLEW SPEED
6 IPS +
6 IPS +
BACKFEED SPEED
2 IPS +
2 IPS +
TEAR OFF +000
- +
- +