Zebra 49834 사용자 설명서
Preventive and Corrective Maintenance
Printed Circuit Boards—DC Motor Maintenance
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
275
DC Motor Maintenance
This procedure is for removing or installing the ribbon take-up or ribbon supply. Read these
instructions thoroughly before starting.
instructions thoroughly before starting.
Tools Required
Installation Instructions
1.
Refer to
and remove the print engine from the applicator and open
the rear enclosure.
Remove the Ribbon Supply/Ribbon Take-Up DC Motor
1.
. Loosen and remove the two 2.5 mm screws that secure the control panel.
2.
. Carefully disconnect the J1 connector from the control panel.
Caution • A qualified service technician must perform this installation.
Caution • Turn OFF (O) the printer and disconnect it from the power source before
performing the following maintenance.
performing the following maintenance.
Phillips Screwdriver Set
Anti-Static Wriststrap and Mat
Standard Hex Key (Allen Wrench) Set
Metric Hex Key (Allen Wrench) Set
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
static-sensitive components such as circuit boards and printheads.