Insignia NS-RSW211 사용자 설명서
11
Rocketboost™ Wireless Subwoofer
www.insigniaproducts.com
Connecting your subwoofer for wireless mode
Important
Every Rocketboost network must contain one hub device, which helps
devices join the network. The network can have only one hub, which you
can enable using the hub switch on the back of all Rocketboost senders
and wireless sender/receivers.
devices join the network. The network can have only one hub, which you
can enable using the hub switch on the back of all Rocketboost senders
and wireless sender/receivers.
The wireless subwoofer is a Rocketboost wireless receiver and is not a hub
device. To add this wireless receiver to your Rocketboost network, you
need to join it to your hub device. This section describes the joining
process.
device. To add this wireless receiver to your Rocketboost network, you
need to join it to your hub device. This section describes the joining
process.
To establish communications:
1
Press the Power button on the Rocketboost hub device to turn it on.
2
Make sure that the INPUT SELECT switch on the subwoofer is set to
Wireless.
Wireless.
3
Make sure that the power switch on your subwoofer is turned on. If the
power indicator is red (Standby mode), briefly press the CONNECT
button to turn on your subwoofer (the power indicator turns blue).
power indicator is red (Standby mode), briefly press the CONNECT
button to turn on your subwoofer (the power indicator turns blue).
4
Press and hold the Power button on the Rocketboost hub device for
more than three seconds to put it into joining mode. The power
indicator starts blinking rapidly and the unit will stay in joining mode
for 30 seconds.
more than three seconds to put it into joining mode. The power
indicator starts blinking rapidly and the unit will stay in joining mode
for 30 seconds.
5
Press and hold the CONNECT button on your subwoofer for more than
three seconds to put it into joining mode.
three seconds to put it into joining mode.
•
When successfully joined, the power indicators on both
products will stop blinking and stay on.
products will stop blinking and stay on.
•
If joining fails after 30 seconds, the power indicators will begin
flashing at a slower rate. If this occurs, repeat the above steps.
flashing at a slower rate. If this occurs, repeat the above steps.
Important
Hub devices must always have power for your network to
operate. The hub device can be in standby (power saving) mode,
but must stay plugged in.
operate. The hub device can be in standby (power saving) mode,
but must stay plugged in.
Note
Rocketboost devices have their own memory. After the devices
are joined once, they remember each other and join
automatically when your devices are powered on again. Because
of this, you can join all of your network components in the same
room before installing them in their permanent locations
throughout the house.
are joined once, they remember each other and join
automatically when your devices are powered on again. Because
of this, you can join all of your network components in the same
room before installing them in their permanent locations
throughout the house.
NS-RSW211_11-0334_MAN_V1.fm Page 11 Monday, May 9, 2011 7:01 PM