E-Mu orbit v2 사용자 설명서
Chapter 5: Edit Menu
65
EDIT MENU
• Crossfade Mode
This function determines which of the following crossfade modes will
be selected: Off, Crossfade, or Cross-Switch.
be selected: Off, Crossfade, or Cross-Switch.
Off
When “Off” is selected, none of the crossfade parameters will
have any effect.
have any effect.
Crossfade
When “Xfade” is selected, a control input is used to fade between
the primary and secondary. Any modulation source may be used
as an input (velocity, wheel, etc.).
the primary and secondary. Any modulation source may be used
as an input (velocity, wheel, etc.).
Cross-switch
When “Xswitch” is selected, the switched layer is selected if the
input crosses a certain threshold or if a footswitch controlling
cross-switch is activated. The switch occurs only at the start of the
note; no further switching takes place while the key is held down.
input crosses a certain threshold or if a footswitch controlling
cross-switch is activated. The switch occurs only at the start of the
note; no further switching takes place while the key is held down.
If key position or velocity is routed to cross-switch, the threshold
is the switch point. Realtime controllers do not have any effect
when routed to cross-switch. For more information, see Cross-
Switch Point on page 67.
is the switch point. Realtime controllers do not have any effect
when routed to cross-switch. For more information, see Cross-
Switch Point on page 67.
XFADE MODE
Off
Off
By overlapping the primary and secondary instruments, you can crossfade or cross-
switch between the layers.
switch between the layers.
••• To use the keyboard for
crossfade, set the Crossfade
Balance to 64 and the Key
Center to the split point.
crossfade, set the Crossfade
Balance to 64 and the Key
Center to the split point.
Primary
Instrument
Key Range
Key Range
Secondary
Instrument
Crossfade Range