kvh 01027702bk install 사용자 설명서

1.

Connect the antenna cable to the antenna. Hand-
tighten, then tighten with a 

7

⁄

16

" wrench for 

1

⁄

4

turn

to ensure an electrical and weatherproof
connection.

2.

Slide the rubber sealing boot up the cable until it
covers the antenna cable connector. This boot will
help protect the connector from the elements.

3.

Choose a location on the roof for the 

1

⁄

2

"-diameter

cable access hole. Inside the vehicle, remove the
headliner to access the underside of the roof
where you will be cutting out the hole.

4.

Using a 

1

⁄

2

" hole saw, cut out the cable access hole

in the vehicle’s roof and smooth the edges of the
hole to protect the cable.

5.

Center the backing plate over the cable access
hole to locate the three fitting mounting holes.
Use a center punch to mark the hole locations. 

54-0350

Installing the Antenna

Rubber Boot

Techniques for removing the headliner vary
from vehicle to vehicle. Only a trained
automotive installer should remove the
headliner. KVH is not liable for damage
caused by improper headliner removal.

Backing Plate

(used as template)