kvh 01027702bk install 사용자 설명서
6.
Set aside the backing plate, then use a
5
⁄
32
" drill bit
to drill the three fitting mounting holes.
7.
Insert the antenna cable into the access hole.
Inside the vehicle, pass the cable through the
backing plate and route the cable to the receiver.
Inside the vehicle, pass the cable through the
backing plate and route the cable to the receiver.
8.
Move the fitting down the cable until it covers the
cable access hole, flush to the vehicle’s roof. Line
up the fitting’s three mounting holes with the
three
cable access hole, flush to the vehicle’s roof. Line
up the fitting’s three mounting holes with the
three
5
⁄
32
" holes drilled in the roof. Apply silicone
sealant or RTV to the holes and insert the #6-32 x
5
⁄
8
" screws supplied in the kitpack.
54-0350
2.18
TracVision A7 Installation Guide
1
⁄
2
" Cable
Access Hole
5
⁄
32
" Fitting
Mounting Hole
Cable Access Hole and Fitting Mounting Holes
Cable Routed Into Vehicle Through Access Hole
Cable Fitting
Fitting Mounted to Roof
Cable Fitting
Clamping Nut