Pentax ist d 작동 가이드
153
Appendix
8
Troubleshooting
We recommend to check the following items before contacting a service
center.
center.
In rare cases, the camera may not operate correctly due to static electricity. This can
be remedied by taking the batteries out and putting them back in again. When the
mirror remains in the up position, take the batteries out and put them back in again.
Then, turn the power on, and turn the power off with pressing the shutter release
button. The mirror will retract. After the procedure is done, if the camera operates
correctly, it does not require any repairs.
be remedied by taking the batteries out and putting them back in again. When the
mirror remains in the up position, take the batteries out and put them back in again.
Then, turn the power on, and turn the power off with pressing the shutter release
button. The mirror will retract. After the procedure is done, if the camera operates
correctly, it does not require any repairs.
Symptoms
Causes
Remedies
The shutter does
not release.
Nothing is displayed
on the LCD panel.
not release.
Nothing is displayed
on the LCD panel.
The lens aperture ring setting is
other than the s position.
other than the s position.
Set the lens aperture ring to the
s
s
position. (p.60)
The main switch is OFF.
Turn the main switch ON. (p.26)
The low battery warning }
is blinking.
is blinking.
Replace the battery. (p.21)
The batteries are installed
upside-down.
upside-down.
Install the batteries properly.
(p.21)
(p.21)
The mode dial is in the 8 or
no
no
position.
Set the mode dial to one of the
capture modes.
capture modes.
The built-in flash is being
charged.
charged.
Wait until the flash is fully
charged. (p.86)
charged. (p.86)
The Autofocus does
not work.
not work.
The subject is not within the AF
frame.
frame.
Move the camera until subject is
inside of the AF frame. (p.17)
inside of the AF frame. (p.17)
The subject is too close.
Increase the camera-to-subject
distance.
distance.
The focus mode is set to z or
k
k
.
Set the focus mode lever to
l
l
. (p.70)
Hard-to-Autofocus subjects
Focus manually by using the
matte field. (p.74)
matte field. (p.74)
AE lock function
does not operate.
does not operate.
AE lock is not available when
set to green operation mode, a
(Metered manual exposure)
mode or p (bulb) mode.
set to green operation mode, a
(Metered manual exposure)
mode or p (bulb) mode.
Set to one of the capture modes
other than the green program
AE mode or a (Metered
manual exposure) mode.
other than the green program
AE mode or a (Metered
manual exposure) mode.
The built-in flash
does not discharge
even if the flash is in
the popped-up
position.
does not discharge
even if the flash is in
the popped-up
position.
When 3 appears on the LCD
panel, the built-in flash does
not discharge in bright lighting
conditions.
panel, the built-in flash does
not discharge in bright lighting
conditions.
(p.86)
The power zoom
system does not
function.
system does not
function.
The camera does not have the
power zoom function.
power zoom function.
Use manual zoom. (p.81)
e_000_kb321.book Page 153 Wednesday, August 27, 2003 12:09 PM