Panasonic ERRZ10 작동 가이드
12
English
Charging stand
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
Lubrication
• Apply the oil to the trimmer before and after each use.
Apply a drop of the oil to each indicated
point.
Attach the blade to the main body, turn
on the power and allow to run for
approximately 5 seconds.
Failure to apply the oil may cause the
following problems due to rust, wear or
burn out.
‑ The trimmer has become blunt.
‑ Shorter operating time.
‑ Louder sound.
►
Replacement parts
Replacement part is available at your dealer or Service Centre
Replacement parts for ER‑RZ10 Blade
WER9340
Troubleshooting
Perform the following actions.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service centre authorized by
Panasonic for repair.
Problem
Action
The trimmer has become
blunt.
Operating time is short.
Trimmer stopped functioning.
Until problems are solved, please
follow each procedure as follows;
1. Charge the trimmer.
(See page 10.)
2. Clean the blade and apply oil.
(See pages 11 and 12.)
3. Replace the blade.
(See page 11.)
4. Have the battery replaced by
an authorized service centre.
The trimmer cannot be
charged.
Insert the appliance plug into the
trimmer firmly.
Charge within the recommended
Charge within the recommended
charging temperature of 0 °C to
35 °C.
Makes a loud sound.
Apply oil. (See this page.)
Confirm that the blade is properly
Confirm that the blade is properly
attached.
ER-RZ10_EU.indb 12
2017/01/13 11:02:01