Netgear AC1600 사용자 매뉴얼

After you turn on power to the router, the following sequence of events should occur:

When power is first applied, verify that the Power/Test LED 

 is lit.

Verify that the Power LED lights amber within a few seconds, indicating that the self-test is 

running.

After approximately 30 seconds, verify the following:

The Powert LED lights solid green.

The Internet LED is lit.

The LEDs on the front panel of the router can be used for troubleshooting.

Make sure that the power cord is securely connected to your router and that the power 
adapter is securely connected to a functioning power outlet. 

Check that you are using the 12V DC, 2.5A power adapter that NETGEAR supplied for 
this product.

If the Power LED blinks slowly and continuously, the router firmware is corrupted. This 
can happen if a firmware upgrade is interrupted, or if the router detects a problem with the 
firmware. If the error persists, you have a hardware problem. For recovery instructions, or 
help with a hardware problem, contact technical support at 

When the router is turned on, the Power LED lights amber for about 20 seconds and then 
lights green. If the LED does not turn green, the router has a problem.

If the Power LED is still amber one minute after you turn on power to the router:

Turn off the power and then turn it back on to see if the router recovers.

Press and hold the Reset button to return the router to its factory settings. 

See 

If the error persists, you might have a hardware problem. Contact technical support at