Comp X Security Products Inc 421860 사용자 설명서
5
2
1
3
4
om00791
1.
Cosmetic plate
2.
Cover
3.
Bracket
4.
Air filter
5.
Backing plate
Figure 58. Air Cleaner
HEADLAMPS: FLHTCUSE3
The headlamp assembly uses a separate replaceable quartz
halogen bulb for the low beam and the high beam. Refer to
Table 13 and see a service manual for more details.
halogen bulb for the low beam and the high beam. Refer to
Table 13 and see a service manual for more details.
To replace the bulbs:
1.
See Figure 59. Remove the small fastener and the head-
lamp door.
lamp door.
2.
See Figure 60. Remove the 3 screws and the reflector/lens
retaining ring (1).
retaining ring (1).
3.
Support the reflector/lens and remove the wire harness
connectors from the bulb connectors.
connectors from the bulb connectors.
4.
Quarter turn the connector to remove a bulb from the
reflector/lens.
reflector/lens.
5.
Quarter turn a new bulb to lock the bulb in the reflector/lens
and mate the wiring harness connectors to the bulb con-
nectors.
and mate the wiring harness connectors to the bulb con-
nectors.
6.
Set the reflector/lens up to the adjustment ring matching
the square tabs to the square recesses in the ring.
the square tabs to the square recesses in the ring.
7.
Align the three taps on the retaining ring with the threaded
holes on the adjustment ring and tighten to hold the
reflector/lens in place.
holes on the adjustment ring and tighten to hold the
reflector/lens in place.
164 Maintenance and Lubrication