Selex ES SPA F567DHDE-HP 사용자 설명서

SELEX Communications

Information contained in this document may not be used, applied or reproduced for any purpose unless agreed

by SELEX Communications S.p.A. in writing

July 2010

E/M Type II provides a four−wire fully−looped arrangement that provides full isolation between the

trunks and signaling units. The following table displays the sent signal states for active/not active

signaling. The RBS grounds its M−lead to signal a seizure. The other device applies battery to its

M−lead to signal a seizure. Prod-El SRB expect to see active conditions on the E−lead and signal

active to the remote device on M−lead.

E/M Type V Interface Model

E/M Type V interface is a symmetrical two−wire lead arrangement that signals in both directions by

means of open for not active and ground for active signalling. The following table displays the sent

signal states for active/not active signaling. The RBS grounds its M−lead to signal a seizure. The other

device applies battery to its M−lead to signal a seizure. Prod-El SRB expect to see active conditions

on the E−lead and signal active to the remote device on M−lead.

E/M Proprietary Type Interface Model

E/M Proprietary Type provides a four−wire fully−looped arrangement that provides full isolation

between the trunks and signaling units. The following table displays the sent signal states for

active/not active signaling. The RBS grounds its M−lead to signal a seizure. The other device applies

battery to its M−lead to signal a seizure. Prod-El SRB expect to see active conditions on the E−lead

and signal active to the remote device on M−lead.

M+

M-

E+

E-

SRB side