Essence Security International ltd. ES7502HC 사용자 설명서
Installing the CP
12
Care@Home™ Control Panel Next Generation User Guide
To mount the CP on a wall:
1. Prepare the following equipment:
A drill with a standard bit
Two 3 X 35 DIN 7982 C screws and wall anchors:
A standard Philips screwdriver
2. Choose a flat, smooth, non-concrete wall.
3. Determine the height at which you want to mount the CP. This is usually the eye level of the
resident when seated.
4. At the desired height, drill two holes 7.5 cm (2.95 inches) away from each other horizontally.
Ensure that they are level.
5. Screw the screws into the holes, leaving a space of a few millimeters between the wall and the
screw heads.
6. Remove the back cover of the CP.
7. Align the screw mount holes on the back cover of the CP over the screw heads.
8. Slide the back cover down gently until the screws lock in place.
9. Reattach the CP to the back cover.
2.5. Configuring the CP Parameters
CP parameters are pre-configured to manage and control the CP and the peripherals associated with
the CP. If required, use the Care@Home™ CMS application to adjust the configuration for the
requirements of the resident and the resident’s family.
the CP. If required, use the Care@Home™ CMS application to adjust the configuration for the
requirements of the resident and the resident’s family.
Refer to the CMS documentation for the version of Care@Home™ installed in the resident’s premises:
PERS: ESUG05071 Care@Home PERS CMS User Guide
Pro or Family: ESUG05074 Care@Home CMS Reference
NOTE:
To receive power fail notification, the CMS Mains Failure CP parameter
must be enabled.