Teltronic AG 812675 사용자 설명서

Exhaust fumes are produced while the
auxiliary heating system is in operation. If you
breathe in these exhaust fumes, you could be
poisoned. Therefore, always switch off the
auxiliary heating in enclosed spaces without
an extraction system, e.g. a garage.

Parts of the vehicle can become very hot
during operation of the auxiliary heating.
Make sure that the exhaust system does not
under any circumstances come into contact
with highly flammable material such as dry
grass or fuels. Otherwise, the highly
flammable material could ignite and set the
vehicle alight.
Auxiliary heating operation is prohibited at
gas stations or when your vehicle is being
refueled. Therefore, the auxiliary heating
must be switched off at gas stations.

The auxiliary heating system operates inde-
pendently of the engine and complements the
vehicle heating or air conditioning.
You can use the auxiliary heating at an out-
side temperature of up to 39 ‡ (4 †) in order
to:

R

pre-heat the vehicle interior

R

additionally warm the coolant, thereby con-
serving the engine and saving fuel

R

support the vehicle's heating system while
the engine is running and outside tempe-
ratures are low (heater booster function)

i

At an outside temperature above 39 ‡

(4 †), the auxiliary heating system and the
heater booster function switch off automa-
tically.

! 

Switch on the auxiliary heating system at

regular intervals (at least once a month) for
approximately 10 minutes.
Make sure that the flow of hot air is not
blocked. Otherwise, the auxiliary heating
will overheat and switch off.

i

If the interior motion sensor is armed and

the auxiliary heating is switched on, it is
possible that the interior temperature
monitoring may cause a false alarm. In this
case, either deactivate the interior motion
sensor or switch off the auxiliary heating.

You can switch the auxiliary heating on/off
using:

R

the on-board computer and the auxiliary
heating switch (

Y

 Seite 5) or

R

the auxiliary heating remote control
(

i

This device complies with part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions:
(1) this device may not cause harmful inter-
ference, and
(2) this device must accept any interfe-
rence received, including interference that
may cause undesired operation.
Changes or modifications made to this
equipment not expressly approved by Telt-
ronic AG may void the FCC authorization to
operate this equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfe-
rence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation.

Y 

page

10).