AngioDynamics UK Limited AS0670 사용자 설명서
DELTA 15/30
DELTA 15/30 Operator Manual
Page 3.4
Version B.2
INSTALLATION AND SET-UP
Installation of the DIOMED DELTA 15/30 can be carried out by the end-user.
Inspection
Inspect the DIOMED DELTA 15/30 and contents for signs of damage. If the unit is damaged DO NOT
USE - contact DIOMED or your local DIOMED representative. If there are no signs of damage and all
components are present, assemble the DIOMED DELTA 15/30.
Check that the following components are included in the packaging
DIOMED DELTA 15/30 Laser unit
Inspect the DIOMED DELTA 15/30 and contents for signs of damage. If the unit is damaged DO NOT
USE - contact DIOMED or your local DIOMED representative. If there are no signs of damage and all
components are present, assemble the DIOMED DELTA 15/30.
Check that the following components are included in the packaging
DIOMED DELTA 15/30 Laser unit
•
Footswitch
•
IEC Power cable
•
2 x Remote Interlock bypass connectors
•
2 x Keys
•
4 x T6.3A fuses
•
Operator Manual
The DIOMED DELTA 15/30 will operate at mains voltages between 100 V and 240 V AC without
adjustment.
1. Connect the footswitch to the footswitch socket (line up red dots and insert).
2. Connect a remote interlock bypass connector to the remote interlock socket (line up red dots
2. Connect a remote interlock bypass connector to the remote interlock socket (line up red dots
and insert).
3. Connect the optical fiber or Spot Handpiece
1
to the laser aperture as described in the section
below.
4. Insert the IEC Power cord into the power inlet socket and connect to the main power supply.
5. Switch the power switch to ON ( | ).
6. Insert a key into the key switch on the front of the unit.
7. The DIOMED DELTA 15/30 is now installed and ready for use.
5. Switch the power switch to ON ( | ).
6. Insert a key into the key switch on the front of the unit.
7. The DIOMED DELTA 15/30 is now installed and ready for use.
Connecting to the Laser Aperture
Laser energy is delivered to the optical fiber or spot handpiece via the laser aperture located on the
front panel of the DIOMED DELTA 15/30. The fiber or handpiece is connected by means of an SMA-
905 type optical fiber connector.
To insert the optical fiber connector, first remove the protective cap from the end of the fiber. Then press
down on the tab of the spring-loaded dust cover, insert the optical fiber connector into the laser aperture
on the DIOMED DELTA 15/30 and turn the gripper clockwise until secured in place (light finger tight
only).
Laser energy is delivered to the optical fiber or spot handpiece via the laser aperture located on the
front panel of the DIOMED DELTA 15/30. The fiber or handpiece is connected by means of an SMA-
905 type optical fiber connector.
To insert the optical fiber connector, first remove the protective cap from the end of the fiber. Then press
down on the tab of the spring-loaded dust cover, insert the optical fiber connector into the laser aperture
on the DIOMED DELTA 15/30 and turn the gripper clockwise until secured in place (light finger tight
only).
1
A Spot Handpiece can only be used with a DIOMED DELTA 15/30 laser fitted with an optical power
calibration port. The Ø 2mm Spot Handpiece can be used with either laser but the Ø 4mm Spot
Handpiece may only be used with the DIOMED DELTA 30.
Handpiece may only be used with the DIOMED DELTA 30.