Philips Electronics Singapore Pte Ltd BC15348 사용자 설명서

7

Your remote is initially programmed to only operate your Qwest set-top box. You will
need to set up the remote control to operate your AUX, TV, and DVD modes. The AUX
key may be programmed to operate a VCR, HTIB, receiver, or amplifier. The TV key
may be programmed to operate a standard or high-definition television (HDTV). The
DVD key may be programmed to operate a DVD player, a CD player, or a VCR. If the
remote provides only limited functionality for a device, you can look for a code that
provides more functionality. Before you begin, make sure you know the brand name of
the device you want to control.

Note: Some remote keys may be assigned to operate one device type only. For example,
volume control may be assigned to the TV only. If this is the case, you can reprogram
power, volume, and channel control using procedures later in this guide.

1. Find the codes for your brand of device in the appropriate setup code list at the end

of this guide. For example, look under TV Group if you need to program the remote
to operate your TV.

Note: If your device is not listed, you may be able to program the remote using the
Auto-Search function.

2. Turn on your device.

3. Press and while holding a mode key (TV, DVD, or AUX) on the remote control,

press and hold the OK key.

4. Release both the desired mode key (TV, DVD, or AUX) and the OK key and all the

mode keys will flash twice.

5. Enter the first 4-digit setup code for the device using the number keys (0-9) on the

remote control. The selected mode key will flash three times to indicate that the code
entry was accepted and return to normal operation.

• When an invalid code is entered, the selected mode key will display a long

flash to indicate that you have not entered the code correctly.

• Should the remote control time-out before you complete the code setup, you will

need to start over. This is indicated by two quick flashes of the green backlighting.

5. Point the remote at the device, and press POWER, PLAY 

, or 

 to test the

device.

6. Did the device operate correctly?

• If yes, write down the code that worked on the cover of this guide.

You may need it again if the device code is accidentally erased.

• If no, repeat these steps using a different setup code.

Note: If none of the codes listed for your brand of device operate the device
correctly, go to What If None of the Codes Work for instructions.

7. Repeat this procedure for each mode key you want to program.