S and C Electric INTELLICOM 사용자 설명서

 

8     S&C Instruction Sheet 1069-500

If you are not using three antennas on each radio, install antennas 

in order, from the front of the unit toward the back. Do not ‘skip’ 

antenna connections.

Mounting Outdoor Antennas

Once you determine which RF band to use, you can order spec-

trum-specific high-gain antennas from S & C or another supplier. 
Many installers prefer to mount the radio and its associated an-

tennas to a short bar, typically about 2 meters long. This entire bar 

assembly is then mounted horizontally to the vertical mast of the 

main antenna structure. 

Mounting the S&C IntelliCom WAN 1720

You can mount the radio to a wall, a light pole, or an irregularly 

shaped pole. The universal mounting bracket has been designed 

with multiple holes and slots to allow mounting with bolts, straps, 

or other methods. Extra nuts and bolts are provided for this pur-

pose; don’t be alarmed if you have leftover fasteners when instal-

lation is complete.
The Universal Mounting Bracket contains holes and slots to al-

low it to be mounted via U-bolts or straps. Use four screws (not 

supplied) to attach the universal mounting bracket securely to the 

wall using the four holes near the top and bottom of the univer-

sal mounting bracket. Use appropriate anchors when attaching to 

masonry or other materials. 

F

igure

 3.3 

Mounting Bracket

Your radio shipped with a two-

piece mounting bracket as shown 

in the upper photo. To mount the 

radio, remove the outer piece, by 

loosening the thumb screws. The 

inner bracket can be left attached 

to the radio, as shown in the 

lower photo.

Setup and Installation