Airspan Networks Inc ASMAX49 사용자 설명서
Cabling The ProST
37
Verify that your SDA-1 is on and receiving power by checking that the green LED light (labeled
POWER) on the SDA-1's front panel is lit. If it is not, see Appendix C, "Troubleshooting".
Using SDA-4S Type II and SDA-4S/VL Type II
The SDA-4S adapters are plugged into a standard electrical wall outlet (110/240 VAC)
using an AC power cord.
The cable setup between the SDA-4S and power outlet includes the following:
The cable setup between the SDA-4S and power outlet includes the following:
Connector: AC IEC 60320 type (female)
Plug: "A" Continental Europe
Cable: 3x1.z0 mm, 10A / 250 VAC (maximum length is 180 cm)
Plug: "A" Continental Europe
Cable: 3x1.z0 mm, 10A / 250 VAC (maximum length is 180 cm)
To connect the SDA-4S to the AC power supply:
1.
Connect the power plug female, at the end of the AC power chord, into the AC power
socket located on the left panel of the SDA-4S.
2.
Plug the power plug male, at the other end of the AC power chord, into the AC power
outlet (110-240 VAC).
3.
Verify that the power is received by the SDA-4S by checking that the POWER LED light
is on.