Mattel Asia Pacific Sourcing Ltd. C4639-04A4R 사용자 설명서

• Your vehicle features the advanced Tyco® R/C MultiBand™

system. This system lets you race your vehicle head-to-head
– against up to two of your friends (up to 3 drivers total) –
without any radio interference from your friends’ transmiters
or vehicles. You must be racing against another Tyco® R/C
MultiBand™-equipped vehicle for this feature to work.

• There’s one MultiBand™ Selector Switch on your vehicle

chassis, and another one on your transmitter. The vehicle
switch has 3 positions: one for each MultiBand™ setting. 

The transmitter switch has 3 positions: one for each
MultiBand™ setting.

• For successful operation, the vehicle switch and the 

transmitter switch must be set to the same MultiBand™ 
setting. When you’re driving by yourself, you can set the
switches to any of the 3 MultiBand™ settings (as long as
they match).

• When you want to race head-to-head, just make sure that

each driver (up to 3 drivers total) has a vehicle and 
transmitter set to a different MultiBand™ setting.

*

The transmitter’s MultiBand™ Selector Switch also serves
as the transmitter’s power switch. To operate your 
vehicle, just turn the vehicle ON; then set the transmitter
switch to the desired MultiBand™ setting. Push any 
transmitter control and you will be able to run and control
your vehicle.

*

You must be racing against another Tyco® R/C
MultiBand™-equipped vehicle for this feature to work. A
non-MultiBand™ vehicle, running on the same frequency
as your vehicle, may interfere with operation of your 
vehicle. If you are racing against a non-MultiBand™ 
vehicle, make sure that vehicle operates on a frequency
different from yours.

*

If you need to change the MultiBand™ setting, first make
sure that your vehicle is turned OFF. Change the switch
position as desired, making sure to change both the 
transmitter AND the vehicle switches. Then turn your
vehicle back ON for more racing action. NOTE: Make 
certain you’re not pressing a transmitter control while
changing selector switch position.

1. To install transmitter battery, open battery cover as shown.
2. Install 2 AA alkaline batteries with polarity (-/+) as shown

inside battery compartment.

3. Replace battery cover.

7.2V d.c.

For detailed information regarding rechargeable battery
charging and safety, please refer to the “Battery
Charging/Care” Section.

1. Rotate the battery door latch to unlocked position and

open the battery door.

2. Insert the charged battery pack into the battery 

compartment as shown.

3. Connect the battery pack’s wire connector to the vehicle’s

charging jack as shown. Make certain the connector is
securely connected.

4. Close the battery door and rotate the battery door latch to

locked position.