RadioFrame Networks Inc MCSERIESHP10 사용자 설명서
Final Checkout and Commissioning
MC-Series High-Power System
998--01
Rev
X1
52
CONFIDENTIAL AND PROPRIETARY
RadioFrame Networks, Inc.
TRADE SECRET INFORMATION
10 Wait approximately 3 minutes for the following indications:
RBS: The STATUS LED for each Group will turn green in this order: A, B and then C.
RBS: The RADIOBLADE TRANSCEIVER STATUS LEDs will turn red and then
green for each present RadioBlade transceiver. If no RadioBlade transceiver is
present, the LED will not light. To verify the contents of the RBS, pull out the shelf
(powering off is not required) and inspect the RadioBlade transceivers and their
respective status LEDs. Referring to Figure 30, reinsert the RBS. To do this, press up
on one side rail locking arm and press down on the other side rail locking arm, and
then push the unit into the rack.
present, the LED will not light. To verify the contents of the RBS, pull out the shelf
(powering off is not required) and inspect the RadioBlade transceivers and their
respective status LEDs. Referring to Figure 30, reinsert the RBS. To do this, press up
on one side rail locking arm and press down on the other side rail locking arm, and
then push the unit into the rack.
BIC CRIC and AIC CRIC: The POWER and STATUS LEDs will turn red and then
green. All other BIC and AIC card LEDs will turn green.
11 Using the breaker on the PDU, turn up RF Shelf 1, RF Shelf 2 and RF Shelf 3 and
then verify that each RF shelf is operational before proceeding.
The POWER and ALARM LEDs on the front of each RF shelf will turn green.
Figure 30 Location of RBS Side Rail Locking Arms
locking arm
locking arm
5.4 System Setup
1 Connect the laptop to port 8 of the BIC CRIC using an Ethernet (Cat-5) cable.