SmartBridges Pte Ltd SPEEDTRAP2 사용자 설명서

 

3. 

Seal the RF connectors both at the antenna and the SB device side 
from the natural elements using weatherproofing tape provided. Do 
not skimp or skip on this.  

4. 

Choose the antenna of the correct gain and radiating angle to meet 
the requirements for the system setup. Avoid using channels which 
are already in use. Use the IEEE 802.11b recommended non-
overlapping channels: 1, 6 & 11 only or any other non-overlapping 
channel combo. The antenna polarity (vertical / horizontal) should 
be consistent for all the stations in the network.  

5.     It is illegal to use an amplifier with this device.

For more details, follow the mounting instructions provided by the antenna 
manufacturer. 

The airPoint XO™ and XO

2

™ provides a weatherproof RJ45 female 

connector for outdoor use. Use an outdoor rated, shielded, Ethernet CAT5 
cable, such as OSP category 5 (BBDN) cable from Superior Essex. Route 
the cable to the outdoor devices, away from any strong electromagnetic 
radiation sources, such as, radio or TV transmitters, power line 
transformers or any other strong Electromagnetic Interference or 
Transmission source. Preferably, the Ethernet cable has to be routed 
through a pipe to the tower on which the unit is mounted. 

Note: 

1. 

Make sure not to use an unnecessarily long Ethernet cable. 

2. 

Make sure the weather proof connector is correctly used as per the 
instructions enclosed with it. The cable entry gland nuts of the 
weather proof connector should be tightened so that no water 
seepage takes place. Do not strain the weather proof connector. 
Make sure to crimp the shield of the cable to the metallic shield of 
the RJ45 connector.