Guardian Instruments Inc. GI0011092001 사용자 설명서
Step 1. Connect Power to J3 Pins 1 and 2.
Step 2. Connect LCD to J1 2x5 header.
Step 3. Turn Power ON.
Step 4. Verify Data on Display is accurate and shows no Communication Errors.
Step 5. Verify Green and Red LEDS are blinking. These LEDs show the TX and RX activity for the
Step 2. Connect LCD to J1 2x5 header.
Step 3. Turn Power ON.
Step 4. Verify Data on Display is accurate and shows no Communication Errors.
Step 5. Verify Green and Red LEDS are blinking. These LEDs show the TX and RX activity for the
radio module.
If Touch Screen Option is installed:
Step 1. Connect the touch screen panel to J6 Pins 1-4.
Step 2. Verify the proper software version is installed.
Step 3. Using the touch screen and a soft pencil eraser touch the corners of the touch screen panel and
Step 2. Verify the proper software version is installed.
Step 3. Using the touch screen and a soft pencil eraser touch the corners of the touch screen panel and
verify the x and y directions coordinates are valid.
Step 4. Verify the audible buzzer feedback for valid touch locations.
If Relay Option is installed:
Step 1. Connect an OHMmeter to J7 Pins 1-2.
Step 2. Verify the OHMmeter reads greater than 1.0 MegOHM.
Step 3. Verify the proper software version is installed.
Step 4. Using the touch screen activate the relay using the test mode.
Step 5. Verify the OHMmeter shows less than 1.0 ohm.
Step 2. Verify the OHMmeter reads greater than 1.0 MegOHM.
Step 3. Verify the proper software version is installed.
Step 4. Using the touch screen activate the relay using the test mode.
Step 5. Verify the OHMmeter shows less than 1.0 ohm.
If High Power Voltage Regulator is installed:
Step 1. Connect the LCD to the system using the standard 10pin ribbon cable.
Step 2. Verify the proper software version is installed.
Step 3. With the radio powered verify the LCD backlighting is turned ON.
Step 2. Verify the proper software version is installed.
Step 3. With the radio powered verify the LCD backlighting is turned ON.
If the 914 Mhz radio is installed:
Step 1. Power a 914 MHz radio receiver/transmitter.
Step 2. Verify Data on Display is accurate and shows no Communication Errors.
Step 2. Verify Data on Display is accurate and shows no Communication Errors.
If the 916.5 Mhz radio is installed:
Step 3. Power a 916.5 MHz radio receiver/transmitter.
Step 4. Verify Data on Display is accurate and shows no Communication Errors.
Step 4. Verify Data on Display is accurate and shows no Communication Errors.
For A2B Display Configurations:
Step 1. Attach the BATTERY LOW LED
Step 2. Attach the COMM FAIL LED
Step 3. Attach the A2BALERT LED
Step 4. Verify all LEDs operate while their respective conditions are TRUE.
Step 2. Attach the COMM FAIL LED
Step 3. Attach the A2BALERT LED
Step 4. Verify all LEDs operate while their respective conditions are TRUE.
If the RS232 option is installed: