Netgear 10300138 사용자 설명서

Configuring a Point-to-Multi-Point Wireless Bridge

Select Configuration > Wireless Bridge > Bridging and Repeating. The Bridging and 

Repeating screen displays.

Configure the operating mode of the access points:

Configure WNAP320 (AP1) on LAN Segment 1 in point-to-point bridge mode with the 
remote MAC address of AP2.

Because it is in the central location, configure WNAP320 (AP2) on LAN Segment 2 in 
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are 
required in AP2.

Configure the WNAP320 (AP3) on LAN 3 in Point-to-Point Bridge mode with the 

Remote MAC Address of AP2.

Verify the following parameters for all access points:

Verify that both access points are configured to operate in the same LAN network 

address range as the LAN devices.

Only one access point is configured in Point-to-Multi-Point Bridge mode, and all the 

others are in Point-to-Point Bridge mode.