Netgear 12300211 사용자 설명서

Enter the settings that you want to customize. These settings are described in the following 

section, 

Click Apply to save your changes.

LAN Setup Screen Settings

. The LAN IP address of the modem router.

. The LAN subnet mask of the modem router. Combined with the IP 

address, the IP subnet mask allows a device to know which other addresses are local to 
it, and which addresses have to be reached through a gateway or modem router.

. Router Information Protocol (RIP) allows a router to exchange routing 

information with other routers. This setting controls how the router sends and receives 
RIP packets. Both is the default setting. With the Both or Out Only setting, the router 
broadcasts its routing table periodically. With the Both or In Only setting, the router 
incorporates the RIP information that it receives.

. This setting controls the format and the broadcasting method of the RIP 

packets that the modem router sends. It recognizes both formats when receiving. By 
default, the RIP function is disabled. 

 is universally supported. It is adequate for most networks, unless you have an 

unusual network setup. 

 carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2 

format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.

Usually, this check box is selected so that the modem router functions as a Dynamic Host 
Configuration Protocol (DHCP) server. 

. Specify the start of the range for the pool of IP addresses in the 

same subnet as the modem router.

. Specify the end of the range for the pool of IP addresses in the 

same subnet as the modem router.

When you specify a reserved IP address for a computer on the LAN, that computer receives 
the same IP address each time it accesses the modem router’s DHCP server. Assign 
reserved IP addresses to servers that require permanent IP settings. See