Netgear WGX102 사용자 설명서
Reference Manual for the 54 Mbps Wall-Plugged Router WGX102
Connecting the Router to the Internet
3-3
July 2004 202-10036-01
•
Wireless: The Wireless light should be lit. If the Wireless light is not lit, see
.
•
LAN: A LAN light should be lit. Green indicates your computer is communicating at
100 Mbps; yellow indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet
cable from the computer to the router is securely attached at both ends, and that the
computer is turned on.
100 Mbps; yellow indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet
cable from the computer to the router is securely attached at both ends, and that the
computer is turned on.
Connect the Wireless Router to the Internet
1. C
ONNECT
THE
WIRELESS
ROUTER
,
THE
COMPUTER
,
AND
THE
MODEM
a.
Turn off computer and modem again?
b.
Locate the Ethernet cable (cable 1 in the diagram) that connects your PC to the modem.
Figure 3-2: Disconnect the Ethernet cable from the computer
c.
Disconnect the cable at the computer end only, point A in the diagram above.
d.
Look at the label on the bottom of the wireless router. Locate the Internet port. Securely
insert the Ethernet cable from your modem (cable 1 in the diagram below) into the
Ethernet port of the wireless router as shown in point B of the diagram below.
insert the Ethernet cable from your modem (cable 1 in the diagram below) into the
Ethernet port of the wireless router as shown in point B of the diagram below.
PRGHP
&DEOH
,QWHUQHW
FRPSXWHU
A