Netgear WGX102 사용자 설명서
Reference Manual for the 54 Mbps Wall-Plugged Router WGX102
Wireless Configuration
4-7
July 2004 202-10036-01
Default Factory Settings
When you first receive your WGX102, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGX102 router, use the procedures below to customize any of the settings to better meet your
networking needs.
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGX102 router, use the procedures below to customize any of the settings to better meet your
networking needs.
How to Set Up and Test Basic Wireless Connectivity
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
established basic wireless connectivity, you can enable security settings appropriate to your needs.
1.
Log in to the WGX102 firewall at its default LAN address of
http://www.routerlogin.net
with
its default user name of admin and default password of password, or using whatever LAN
address and password you have set up.
address and password you have set up.
FEATURE
DEFAULT FACTORY SETTINGS
Wireless Access Point
Enabled
Wireless Access List (MAC Filtering)
All wireless stations allowed
SSID broadcast
Enabled
SSID
NETGEAR
11b/g RF Channel
11
Mode
g and b
Authentication Type
Open System
WEP
Disabled
Note:
If you use a wireless computer to configure WPA settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless router from a wired computer to make any further
changes.
new settings or access the wireless router from a wired computer to make any further
changes.