Radwin Ltd. WINLINK 사용자 설명서

Chapter 4  Operation 

AirMux-104 Installation and Operation Manual 

4-2 Operating 

AirMux-104

 

 

RSS/SNR  

(triple yellow LED) 

ON (AirMux-104 units are not synchronized) – Received signal 

strength 
ON (AirMux-104 units are synchronized) – Signal-to-Noise 
ratio 

RT 

LINK  
(square green LED) 

OFF – AirMux-104 units are not synchronized 
ON – AirMux-104 units are synchronized 

RT 

STATUS  

(circular green LED) 

Blinks slowly – AirMux-104 units are not synchronized 
Blinks rapidly – AirMux-104 units are synchronized 

RT 

 

To turn on AirMux-104: 
•  Connect the AC/DC converter to the RTCB power connector and to the mains. 

The PWR indicator lights up and remains lit as long as the RTCB receives 
power. 

AirMux-104 requires no operator attention once installed, with the exception of 
occasional monitoring of front panel indicators and statistics data. Intervention is 
only required when AirMux-104 must be configured to its operational 
requirements, or diagnostic tests are performed. 

Upon turning on AirMux-104, the PWR LED in the front panel lights to indicate 
that AirMux-104 is on. 

 shows the correct status of the indicators a few 

seconds after power-up. 

PWR ON 

RTCB ON 

If the above LED indications do not appear following initial power turn-on, refer to 

 for the diagnostic test instructions. 

 

To turn off AirMux-104: 
•  Remove the AC/DC converter power cord from the mains.