Curtiss Wright/Vista Controls QUPID2003 사용자 설명서
The information contained herein is proprietary REVISION 2
information subject to the restrictions stated on the front page.
information subject to the restrictions stated on the front page.
- 7 -
CAUTION: Care should be taken during set-up and take down of the sensor.
Allowing the sensor to fall could injure personnel and damage equipment.
Allowing the sensor to fall could injure personnel and damage equipment.
4.5
Attach the power/sensor alarm cable to the mounting fixture using wire ties, leaving an
approximately fifteen (15 cm) centimeter loop before the first wire tie is installed (Figure
4-2) Item 1). This will prevent any stress being placed on the cable and the cable clamp.
Place wire ties at approximately thirty (30 cm) centimeter intervals for the entire length
of the mounting fixture (Figure 4-1, Item 2)
approximately fifteen (15 cm) centimeter loop before the first wire tie is installed (Figure
4-2) Item 1). This will prevent any stress being placed on the cable and the cable clamp.
Place wire ties at approximately thirty (30 cm) centimeter intervals for the entire length
of the mounting fixture (Figure 4-1, Item 2)
Figure 4-2 Power/Alarm Cable Routing
1
2