Karlnet Inc. KS-CPO010124B 사용자 설명서
525 Metro Place North, Suite 100
Dublin, OH 43017
Dublin, OH 43017
KarlNet
Office: 614-822-5275
Fax: 614-822-0024
www.karlnet.com
Fax: 614-822-0024
www.karlnet.com
Configure the Unit
The KarlNet Kbridge Configurator handles configuration. Both the executable file
needed to launch the Configurator (kbwin.exe) and the online help for the Configurator
(kbwin.chm) are included on the Getting Started disk that you received with your
hardware device. Refer to the online help for instructions on how to configure your
device.
Align and Test the Unit
The KarlBridge Configurator’s Wireless Link Test screen is used to diagnose the wireless
link quality between a WISP Base Station (WBS) and your SSU or CSU unit.
The Wireless Link Test displays the diagnostic counters that apply to the selected
radio interface (Slot A or B) and a single remote station connected to this base
station. To assess the overall wireless performance in the wireless area served by
the base station you might need to run Remote Link Tests with multiple stations (one
by one).
Before Running the Link Test
Your SSU or CSU must be associated with a Wireless Base Station (WBS) before
running the Wireless Link Test. Therefore, before you proceed you must know the
following information about the base station to which you will be linking:
SNMP R/W Password
Channel Frequency
Network ID
Network Name
WEP Key (if applicable)
System Access Password
Channel Frequency
Network ID
Network Name
WEP Key (if applicable)
System Access Password
You must now make sure that this information is the same for both your remote unit (the
SSU or CSU) and your WBS.
Note: If you are already familiar with how to associate your remote unit and base
station, skip to the Running the Link Test section.
To ensure that you have matching information:
11