Marasst Incorporation 03010 사용자 설명서
18
Follow the instruction below to set up channels for multiple transmitters.
1. Assemble and install each of the cameras as described in “Setting
Up the Camera/Transmitter” on page 5. Make sure the cameras are turned on.
2. Set the channel of the first camera to channel 1 by pressing the
channel selector button until the first channel indicator LED is lit.
3. Set the second camera to channel 2. If you have a third and fourth
camera, set them to channels 3 and 4 respectively.
4. Turn the video monitor/receiver on and set it to either audio/video
or audio mode.
5. Check the reception of each channel by pressing the channel selec-
tor button on the video monitor. If the audio or video signal of a
channel is unclear, adjust the antenna angle of the camera corre-
sponding to that channel. Refer to the Troubleshooting section on page 26 for more information.
channel is unclear, adjust the antenna angle of the camera corre-
sponding to that channel. Refer to the Troubleshooting section on page 26 for more information.
Adjusting the Focus
The Guardian Angel camera lens focus can be adjusted by turning it
clockwise or counter-clockwise as shown in the following figure .
Adjust the lens focus ring so that the image on the video monitor screen
is clear.
clockwise or counter-clockwise as shown in the following figure .
Adjust the lens focus ring so that the image on the video monitor screen
is clear.
Lens focus ring
Marasst.book Page 18 Thursday, June 19, 2003 6:05 PM