Controlled Electronic Management Systems Ltd INFOPROX 사용자 설명서
InfoProx Entry
Diagnostic Routine
If an exit reader is connected to the entry reader, the diagnostic routine tests the
exit’s LED’s and keypad in the appropriate sequence, as explained in the
Installation Guide. When the entry reader is in diagnostic mode, if there is an exit
reader connected, the routine would be as follows: entry tested, then exit reader
tested, in sequence through the routine – such as entry LED’s, exit LED’s, and so
on.
exit’s LED’s and keypad in the appropriate sequence, as explained in the
Installation Guide. When the entry reader is in diagnostic mode, if there is an exit
reader connected, the routine would be as follows: entry tested, then exit reader
tested, in sequence through the routine – such as entry LED’s, exit LED’s, and so
on.
Final Diagnostic Checklist
1.
Use the InfoProx Reader diagnostic routine to check the functionality of the reader.
Present a valid card to ensure that the reader performs as required.
Present a valid card to ensure that the reader performs as required.
2.
Secure the adapter plate to the containment box, position the reader, and tighten the
two pin-hex security screws ensuring that they are not over tightened.
two pin-hex security screws ensuring that they are not over tightened.
Note
To prevent light from triggering the tamper sensor, ensure that there are no
gaps around the unit.
gaps around the unit.
3.
Fit the cover buttons firmly in place over the screws.
Note
To remove the cover buttons, use a screwdriver on the outer edges to lift the
covers.
covers.
Software House
59