CommScope Technologies LLC S1000C 사용자 설명서
Chapter 2
Getting Started
S1000C User Guide, Release 1.5
2-7
D
R
A
F
T
When is your S1000C ready to use?
When you install and power on your S1000C for the first time, it will go through an
automated setup sequence.
automated setup sequence.
The side of the device marked 'DATA' displays LEDs for 4G LTE data passing
through the device. The side of the device labeled 'VOICE' displays LEDs for 3G
voice signals.
through the device. The side of the device labeled 'VOICE' displays LEDs for 3G
voice signals.
NOTE
Data LEDs and Voice LEDS must be solid green before the S1000C is ready for
data and voice traffic.
data and voice traffic.
4G DATA LEDs
shows the S1000C LED states on the DATA side during normal boot-up.
Refer to
Table 2-1. 4G Data LED states during S1000C boot sequence
WAN
NET
GPS
LTE
WiFi
S1000C State
Performing initial HW tests (1-2
seconds)
seconds)
HW tests are complete; software
is loading.
is loading.
Software is loaded; services are
initializing.
initializing.
WAN port is connected over the
local network; IPSec tunnel is not
established.
local network; IPSec tunnel is not
established.
WAN port is connected; IPSec
tunnel is established and UP.
tunnel is established and UP.
WAN port is connected; IPSec
tunnel is established and UP; GPS
Time Fix is available; LTE
service is UP.
tunnel is established and UP; GPS
Time Fix is available; LTE
service is UP.