HIMS International Corporation B14K 사용자 설명서
4) Arrow down to "Braille Settings" and press "Enter".
5) Choose "HIMS Smart Beetle" from the Braille Display combo box.
6) Tab to the "Port" combo box and ensure that it is set correctly.
(NVDA employs automatic port detection, so you should not need to
change this setting)
change this setting)
7) Tab among the various combo boxes to choose options such as
output and Input tables, cursor options, etc. Use the Up and Down
arrows to navigate among the choices in each combo box.
arrows to navigate among the choices in each combo box.
8) When you have finished selecting your settings, Tab to "OK" and
press "Enter".
Note: Make sure the "Save configuration on Exit" box is checked
in the NVDA menu in order to ensure your settings for the Smart
Beetle are saved, thus the HIMS Braille device will automatically
connect each time you use NVDA in the future.
Beetle are saved, thus the HIMS Braille device will automatically
connect each time you use NVDA in the future.
4.6 Using the Smart Beetle with System Access
Currently, The Smart Beetle works with System Access using only a
Bluetooth connection. To use your Smart Beetle as a Braille display with
System Access, ensure it is powered on, it is in "Pairing BRL" Mode, and
that it has been paired with your PC. When System Access is started,
the device is automatically detected, and Braille begins displaying.
Bluetooth connection. To use your Smart Beetle as a Braille display with
System Access, ensure it is powered on, it is in "Pairing BRL" Mode, and
that it has been paired with your PC. When System Access is started,
the device is automatically detected, and Braille begins displaying.
4.7 Using Smart Beetle with VoiceOver on the Mac
To use a Smart Beetle as a USB braille display with a Mac running
VoiceOver, you can simply power on the device, make sure it is in "USB"
Mode and connect it to the Mac via USB. The unit is immediately
recognized and VoiceOver output is shown on the Braille display.
VoiceOver, you can simply power on the device, make sure it is in "USB"
Mode and connect it to the Mac via USB. The unit is immediately
recognized and VoiceOver output is shown on the Braille display.
Use the following steps to connect the Smart Beetle as a Bluetooth
Braille display with a Mac running VoiceOver:
Braille display with a Mac running VoiceOver:
1. Ensure that the unit is powered on, Bluetooth is activated, and it is
in "Pairing BRL" Mode.
2. Press Vo-F8 to open the voiceOver Utility.
3. Navigate to "Categories" and press Vo-Shift-Down to begin
interacting with it.
4. Press B for Braille.
5. Press Vo-Shift-Up to stop interacting with the Categories group.