Humax T9 사용자 설명서
Confidential
DUT Graphical User Interface
DUT Tool Package
Using the DUT GUI
User’s Guide
16
Revision 1.1, 2013-05-06
For example: XTAL_CAL_BIAS = 70 should be used for TXC part.
Non-Volatile memory type
NV_MEMORY_TYPE0 = 1
// Wlan0 memory type
NV_MEMORY_TYPE1 = 1
// Wlan1 memory type
Select the memory type used for storing HW related data.
1 - eeprom, 2 - flash, 3 - efuse
1 - eeprom, 2 - flash, 3 - efuse
Fast Operation
FAST_RESTART_METHOD = 1
0 - Regular Mode
1- Fast Restart mode
0 - Regular Mode
1- Fast Restart mode
Note:
1. Other parameters in dut_cfg.txt are used for debug and should not be modified.
2. In case improper hardware type was chosen, it may be required to reboot the DUT host (system to which the
2. In case improper hardware type was chosen, it may be required to reboot the DUT host (system to which the
device is connected) before reconnection.
5.2
Setting the DUT's Channel
Figure 8
Channel Setting and Transmission Screen
When the DUT GUI is initialized, it sets the DUT to a channel according to the last run. You can select different
parameters and set the DUT's channel using the following options:
•
parameters and set the DUT's channel using the following options:
•
PHY Type - Used to select the operation band. PHY type also depends on the type of packets the DUT will
transmit. However, if a PHY type of 2.4 Ghz is chosen (for example - 802.11b
transmit. However, if a PHY type of 2.4 Ghz is chosen (for example - 802.11b
) the DUT will also receive
and analyze 802.11g and 802.11n packets.
•
Spectrum BW (Band width) - Dictates the spectrum bandwidth of the transmission:
– Non-channel Bonding (nCB) = 20 Mhz
– Channel Bonding (CB) = 40 Mhz
– Non-channel Bonding (nCB) = 20 Mhz
– Channel Bonding (CB) = 40 Mhz