Honeywell International Inc. TH5320R01 사용자 설명서
Install batteries in wireless devices
1
When system wiring is complete and TrueZONE panel is configured for RF,
install batteries in all devices. Make sure batteries are inserted properly (see
illustrations below).
install batteries in all devices. Make sure batteries are inserted properly (see
illustrations below).
3
Español: vea la página 16 • Français : voir la page 31
Link all devices to wireless network
2
Make sure the Connected light on the
wireless adapter is flashing green.
wireless adapter is flashing green.
If the light stops flashing before you
have linked all devices, press
have linked all devices, press
CONNECT
again.
Press
CONNECT
Flashing status light times out after 15
minutes of inactivity. Press
minutes of inactivity. Press
CONNECT
again if
necessary.
Continued on next page
>>
If light does not flash, another EIM/wireless
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless
adapter.
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless
adapter.
Thermostat
Install quick reference card
Install 2 fresh AA
batteries
batteries
Remote control (optional)
Outdoor air sensor (optional)
Install 3 fresh AA
batteries
batteries
Install 2 fresh AA
lithium
lithium
batteries
Programmable models only