Honeywell International Inc. TH5320R01 사용자 설명서
Link remote control to wireless network (optional)
Link outdoor sensor to wireless network (optional)
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press the
CONNECT
button on the back
of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
(If you are installing more than one zone
panel, repeat steps 1-3 for each.)
panel, repeat steps 1-3 for each.)
Press and release
5
Español: vea la página 16 • Français : voir la page 31
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press
CONNECT
at the remote. There will
be a short delay as the remote seeks
a signal from the wireless network.
a signal from the wireless network.
3 When the screen displays
“Connected,” press
DONE
.
4 Press
NO
at the next screen to save
and exit. (Or press
YES
and repeat
steps 1-4 to link another zone panel.)
If E1 appears, see error codes on page 12.
WIRELESS SETUP
CONNECT
YES
NO
CONNECT MORE?
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if
present) in the lower right corner of the screen
until the display changes (about 3 seconds)
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if
present) in the lower right corner of the screen
until the display changes (about 3 seconds)
Press to link another
zone panel
zone panel
Press to save
and exit
and exit