Zebra Technologies Corporation RFID-Z4M-01 사용자 설명서
85
R4Mplus User Guide
Routine Care and Adjustments
Cleaning Procedures
Clean the Rewind Option
and perform the following procedure if
adhesive buildup begins to affect peel performance.
To clean the Rewind option, complete these steps:
1. Open the printhead assembly.
2. Close the peel assembly to prevent bending the tear-off/peel-off bar during cleaning.
3. Use the Preventive Maintenance Kit (Zebra part number 47362) or a solution of
3. Use the Preventive Maintenance Kit (Zebra part number 47362) or a solution of
90% Isopropyl alcohol and 10% deionized water and swab to remove excess adhesive
from the tear-off/peel-off bar. Allow the solvent to evaporate.
from the tear-off/peel-off bar. Allow the solvent to evaporate.
4. Open the peel assembly by pivoting the module toward you.
5. Manually rotate the pinch roller and clean thoroughly with solvent and a swab. Allow the
5. Manually rotate the pinch roller and clean thoroughly with solvent and a swab. Allow the
solvent to evaporate.
6. Close the peel assembly.
7. Close the printhead assembly.
7. Close the printhead assembly.
Figure 31 • Cleaning the Rewind Option
Caution • Ensure that the printhead is fully open and engaged in the up
position. If the printhead is not latched in the up position, it could fall on your
hand during the procedure.
position. If the printhead is not latched in the up position, it could fall on your
hand during the procedure.
Note • Apply minimum force when cleaning the tear-off/peel-off bar. Excessive
force can cause the tear-off/peel-off bar to bend, which can have a negative
effect on peel performance.
force can cause the tear-off/peel-off bar to bend, which can have a negative
effect on peel performance.
1
Printhead Assembly
2
Tear-Off/Peel-Off Bar
3
Pinch Roller
4
Peel Assembly
3
2
1
4