Nokia Solutions and Networks T5DK1 사용자 설명서
Alarm / Span Cabling
68P64115A19
–
4
Mar 2003
1X SC 4812T-MC BTS Hardware Installation - Software Release R2.16.1.x
CONTROLLED INTRODUCTION
2-10
Alarm / Span Cabling
Objective
The objective of this procedure is to install the BTS alarm and span line
cabling.
cabling.
Cable Labels
The cable designations are referenced to Table 2-1 in the “Overall
Cabling Diagrams and Description” area.
Cabling Diagrams and Description” area.
Equipment Needed
Table 2-2 lists the quantity and description of the required cables.
Table 2-2: Cables Needed for Alarm and Span Line Cabling
Cable
Qty.
Part Number
Description
A
1 or 2
CGDS1583461
Cable, 50-wire, shielded twisted 25 pair, 100 ohm, 24-AWG, 7.6 m
(25 ft), one male TELCO connector attached. One end of cable has
shielded twisted pairs, no connector.
(25 ft), one male TELCO connector attached. One end of cable has
shielded twisted pairs, no connector.
CGDS1583462
Cable, 50-wire, shielded twisted 25 pair, 10 ohm, 24-AWG, 15.2 m
(50 ft), one male TELCO connector attached. One end of cable has
shielded twisted pairs, no connector.
(50 ft), one male TELCO connector attached. One end of cable has
shielded twisted pairs, no connector.
B
2
CGDS1583451
Cable, 60-wire, 100 ohm, 24 AWG, 7.6 m (25 ft), one 60-pin
connector. One end of cable has shielded twisted pairs.
connector. One end of cable has shielded twisted pairs.
CGDS1583452
Cable, 60-wire, 100 ohm, 24 AWG, 15.2 m (50 ft), one 60-pin
connector. One end of cable has shielded twisted pairs.
connector. One end of cable has shielded twisted pairs.
2