Roseman Engineering Ltd. FG3E 사용자 설명서
Fleet Gate Installation Guide Roseman Engineering Ltd
26
The Fueling Division of Roseman Engineering Ltd.
8. Completion of Installation
8.1 Verify Installation
When installation is complete, verify that the GREEN LED on the FG3 is
blinking every second. This indicates good power and grounding.
blinking every second. This indicates good power and grounding.
There are three indicator LEDs on the FG3 (refer to Figure 2) a RED, GREEN and
YELLOW LED :
YELLOW LED :
LED COLOR
FUNCTION
INDICATION
RED
CAN BUS
When no data received blinks every 2 sec.
When data received blinks according to the
data rate
data rate
GREEN
Power and RF
RF transmission - Fast blinking
Power ON- Blinks every second
YELLOW
GPS/GPRS
Note
During normal operations, the green LED also blinks every time an
RF message is received, indicating that the FG3 is communicating
with the WAF or VDC antenna.
RF message is received, indicating that the FG3 is communicating
with the WAF or VDC antenna.
After power up, the green LED blinks every second. (Indicating a
good power and ground).
good power and ground).
In addition the green LED blinks every time an RF message is
received. (Indicating the FG3 is communicating with the WAF or
VDC antenna)
received. (Indicating the FG3 is communicating with the WAF or
VDC antenna)
When the FG3 is set to Hour counter and the input VSS set on, red
LED is on.
LED is on.
(Indicating good communication with the vehicle/equipment).
8.2 Post Installation Steps
The next step is to program the FG3 For instructions, refer to the FG3
Programming Guide.